Question:

Could you advise on how to set a slideshow created with FXWitz Flash SlideShow Editor to repeat continuously?

Answer:

Begin by opening the FXWitz Flash SlideShow Editor and loading the project you wish to edit.

Step 2: Access the Playback Settings

Navigate to the ‘Settings’ or ‘Options’ menu within the editor. This is typically found in the toolbar or under a menu labeled ‘Edit’ or ‘Project’.

Step 3: Modify the Loop Setting

Look for a playback option labeled ‘Loop’, ‘Repeat’, or something similar. This setting controls whether your slideshow plays just once or loops continuously.

Step 4: Enable Looping

Enable the looping feature. There may be a checkbox, a toggle switch, or a dropdown menu where you can select ‘Loop Continuously’ or ‘Repeat Forever’.

Step 5: Save Your Changes

After enabling the loop setting, make sure to save your changes. It’s always a good idea to preview your slideshow to confirm that it loops as expected.

Step 6: Export or Publish

Once you’re satisfied with the looping functionality, you can export or publish your slideshow. If you’re sharing it online or embedding it into a website, ensure the loop setting remains active in the final version.

Additional Tips:

• If you’re adding music to your slideshow, ensure the track is long enough to cover the entire duration of the loop, or select a track that naturally loops well.
• Consider the audience’s experience; a continuously looping slideshow should not be too lengthy or contain overly distracting transitions.

By

following these steps, you should be able to set your FXWitz Flash SlideShow Editor project to loop continuously, providing a seamless viewing experience for your audience. Remember, the exact terms and locations of these settings might vary slightly depending on the version of FXWitz you are using, so if you’re ever in doubt, consult the software’s help section or user manual for guidance.